Craftsman 320.28160 Product Manual page 14

ATTACHING THE LEGS TO THE TABLE TOP
1.
2.
3.
4.
Place the router table
surface upside down on
a flat, level surface, with
the underside of the table
facing up.
Position the legs relative to
the router table as shown
in Fig. 2.
Position one short end of
the table so that it extends
beyond the edge of your
work surface far enough
to gain access to the four
holes in that end of the
router-table top.
Align the two outermost
holes on the table top with
the holes in the leg bracket.
i
t
5.
6.
Place a flat washer (12) onto
each of two short, pan-head
screws (8). Insert the short,
pan-head screws up through
the holes in the table and
through the holes inthe leg
bracket. Place a small washer
(12), a spring washer (13), and
small nut (10) on the threads
of the screw. Loosely tighten
the nuts. (Fig. 2)
Place a flat washer (12)
onto each of two long,
pan-head screws (7). Insert
the long, pan-head screws
up through the other two
holes on the table top and
Fig. 3 S
through the corresponding holes in the leg. Place a small washer (12), a spring
washer (13), and small nut (10) on the threads of the screw. (Fig. 3)
7. Securely tighten all fasteners.
8. Repeat with the other leg.
28160 Manual_Revised_07-0228 Page 14