Advertisement
Swlve!
pegs
are
to
be
used
to
grip workplace only In cases where the
workplace DOLES NOT extend beyond the surface of the
Jaws.
Figure
g
=,
_:_
3+
Close
table
top Jaws until narrow
enough
for
workplace,
Place
workpleoe
In vertloal groove in
peg support
and tighter
table
top jaws
until
workplace Is secure. (Sea F3gum 11.)
Flgure
11
Check cross
piece tO
see If It Is In the way.
Using
Adjustable
Peg
Supports
Your Clamping Table Is equipped with 2 peg eupportm
with horizontal and vertlcal V-gropves to grip pipes and
other round shaped _vorkplecee
on the edge of table top
JEW+,
To Hold
Round
Workpleces
Horizontally
1= Push swivel pegs and peg supports
Into holes on
the edge of rear Jaw. (See Figure 10.)
2.
Close
table top Jaws untll narrow
enough
for
worl<pteoe, Place workplace
In horizontal grooves
in peg supports
and tighten table
top Jaws until
workple_e Is secure,
Figure
10
To Hold
Round
tNorkpieoee
Vertically
1.
Push swivel peg and peg support Into hole on the
edge of front Jaw,
2.
Push swivel peg and peg support
into hole in the
same position on edge of rear Jaw.
Folding
Clamping
Tabl e for Storage
and
Carrying
1,
Remove any hand tools or parts from stand top and
storage rack, Close the table Jaws together,
2,
Turn handles countemlockwlse
to loosen top. Pivot
the top to the forded posit]on, (See Figure 12.)
3+
Tilt stand
back slightly
onto rear Jags. (See Figure
mJ
4.
Reach down and push front legs backward
5.
Tighten handles by turning clockwlse.
Figure
12
To
prevent
personal
injury
while
open]ng
or cloBing
your
Clamping
Table,
always
avoid
po0itionlng
hands
o_ fingers
where
they coulcl get plnohed.
Advertisement
