Advertisement
CARTON
CONTENTS
1. Poly Tray
2. Wheel Support
3. Latch Stand Plate
4. Latch Stand Bracket
5. Axle
6, Wheels (2)
7, Draw Bar Tongue
8. Latch Lock Lever
9, Hitch Bracket
j5
.....
2
TOOLS
REQUIRED
FOR ASSEMBLY
(1)
Screwdriver
(1)
Pliers
(2)
7/16" Wrenches
(2)
1/2" Wrench
(2)
9/16" Wrenches
Remove the hardware pack and all loose parts from
the carton.
Be sure the carton is empty before
discarding.
Lay out and identify all the parts and hardware as
shown on pages 3 and 4.
Place the latch lock lever through the slot in the
draw bar tongue as shown in figure 1. Assemble
the 5/16" x 3-3/4" hex bolt through the tongue, the
lever and two 5/16" hex nuts (one on each side of
the lever). Assemble the 5/16" hex lock nut onto
the end of the bolt and tighten
so that the bolt can
still rotate freely. Tighten
the two 5/16" hex nuts
against the sides of the latch lock lever so that the
lever is centered in the slot. See figure 1,
5116" HEX
NUTS
LATCH
LOCK
LEVER
/
DRAWBAR TONGUE
5116" x 3-3/4" _
HEX BOLT
FIGURE 1
Advertisement
