Table of Contents
Advertisement
aNSTALLATJON
installations
using a High Frequency
Arc Stabilizer
Attachment
will
produce
some
radio
frequency
radiation and will impose some high vottages on the
welder, The following
installation
instructions
must
be followed
carefully
to minimize
these effects°
WARNING: The voltages imposed on the welder by
a High Frequency Arc Stabilizer can damage the
welder° In addition, welding with the Gas-Tungsten
Arc (GTAW) process and AC welding current can
cause welder overheating.
Install High Frequency
Arc Stabilizers only with welders recommended
by
their manufacturer for use with High Frequency Arc
Stabilizers. Consult with the welder manufacturer
regarding
possible
derating
or
duty
cycle
reductions
if the welder
is to be used for
AC
Gas-Tungsten
Arc (GTAW) Welding.
ASSEMBLY
Remove the electrode
holder and work clamp from
your welder
cables and cut welder electrode
and
work cables to two feet long, Strip
,75 inches of
insulation
from the end of each cable,
2 FEET
.75 INCH
STRIP
Install the Plug Assembly provided in the loose parts
bag on the electrode cable from the welder as follows:
1. Unscrew the Insulator
from the plug and place
over the electrode
cable from the welder,
INSULATOR
\
ELECTRODE CABLE
FROM THE WELDER
PLUG
2. Using a 1/8 inch hex "L" wrench,
back out the
set screw in the plug until the electrode
cable
end can be inserted easily
3. Make sure the wire strands on stripped
end of
electrode
cable have not been "frayed",
Twist
together with fingers if necessary,
4., Insert end of electrode
cable
into plug and
tighten the set screw very firmly
5 Thread the Insulator
over the plug and tighten
hand tight,
INSULATOR
1/8" HEX "L" WRENCH
\
Install the terminal
lug provided
in the loose parts
bag on the work cable from the welder as follows:
1, Using a large screwdriver,
loosen the screw in
the terminal lug until the work cable end can be
inserted easily.,
2., Make sure the wire strands on stripped
end of
work
cable
have
not
been
"frayed",
Twist
together
with fingers if necessary
37 Insert end of work cable into terminal
lug and
tighten the screw very firmly,
TIGHTEN
HAND TIGHT
t
LARGE
\ii_ SCREWDRIVER
_--'__
TERMINAL
WO _"__
FROM THE WELDER
Advertisement
Table of Contents
