Advertisement
Care and Cleaning
Burn Hazard
Allow heating element to cool before
cleaning the interior.
Failure to do so can result in burns.
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher,
check to make sure it is clean so the
dishwasher
will drain properly.
A drain air gap is
usually mounted
on countertop
and can be
inspected
by removing
the cover. This is not part
of your dishwasher
and is not covered
by warranty.
Outside--Occasionally
wipe with a mild
nonabrasive
detergent
and water.
Rinse and dry.
Models
with Easy Care Real Stainless
Finish
--Clean
outer door with warm soapy water and a
dishcloth
or sponge.
Rinse with clean water and a
dry cloth. Do not use harsh cleaners.
Inside--The
inside of the dishwasher
is self-
cleaning
with normal use. If needed,
clean around
the tub gasket
area with a damp cloth.
The filter is self-
cleaning.
A glass
trap located
in the
center of the filter
is designed
to
collect pieces of
broken
glass,
straws,
bones
and
pits. To remove
items in glass trap,
grasp handle,
lift
out, empty and
replace.
Note:
Hard water may cause lime deposit
buildup
on the interior of the dishwasher.
Overfill
Protector--keeps
dishwasher from
overfilling
and is located
in the left front corner
of the tub.
• Clean occasionally
with
household
cleaner
containing
vinegar
or
bleach to dissolve
any
buildup.
• Overfill
Protector
should move up and
down freely about one
inch. If it does not
move, lift and clean underneath.
Property
Damage
Hazard
Freezing temperatures
may cause water lines to
rupture. Be sure all supply lines to and circulating
lines
within dishwasher
are protected.
Failure to do so could
result in property damage.
Winterizing
A dishwasher
left in an unheated
place should
be
protected
from freezing.
Have a qualified
person
do the following:
To Disconnect
Service:
1. Turn off electrical
power to the dishwasher
at
the supply source by removing
fuses or
tripping
circuit breaker.
2. Shut offwater
supply.
3.
Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4.
Disconnect
drain line from pump and drain
water into pan.
Note:
See Installation
Instructions
for more
details.
To Restore
Service:
1. Reconnect
the water,
drain, and electrical
power supply.
2. Turn on water and electrical
power supply.
3.
Fill both detergent
cups and run dishwasher
through
a POTS & PANS cycle.
4. Check
connections
to make sure they do not
leak.
Note:
See Installation
Instructions
for more
details.
7
Advertisement
