Frigidaire GCET1031FS4 Use And Care Manual page 6

/,
/' /
// /
/' /
,/ /
//// ///
/' /
/ //
, i //
/'
\
\
Do not load items above
top of agitator vanes in wash tub.
iJ
i'
///' /
/// ///
Built-In Fabric Softener Dispenser
(some models)
Built-In Fabric Softener Dispenser
(some models)
DO NOT REMOVE
SERVICE CAP
FOUND INSIDE
THE AGITATOR
POST.
Safety Lid Lock
Washing Procedures con't
6. Add laundry load to washer.
,, Dry load level should not be higher than the top of agitator vanes.
Do not ovedoad the washer.
,, Do not put items on top of agitatororwrapthem around it. Load items
evenly.
,, Combine large and small items in a load. Load large items first. Large
items should not be more than half the total wash load.
,, When washing a single heavy item, add 1 or 2 towels to balance the
load.
7. If desired, add liquid fabric softener to Fabric Softener Dispenser
(available on some models).
For models with a built-in dispenser (see picture to the left):
1. Add liquid softener to the dispenser, following fabric softener label
directions.
2. Add water to bring liquid level to fill line on dispenser cap.
3. Remove the dispenser from the agitator after each use. Rinse both
cap and cup with warm water. Replace dispenser in the agitator.
NOTE: To separate cap from cup, put thumb into dispenser and push
against side of cup (see picture to the left). After cleaning, push cap and
cup firmly together. Replace dispenser by lining up the ribs and grooves
and snapping it into position. If fabric softener builds up in or around the
dispenser, clean the area with hot water.
DO NOT REMOVE SERVICE CAP FOUND INSIDE THE AGITATOR
POST.
8.
For models without a fabric softener dispenser, follow fabric softener
label directions. Add diluted fabric softener to the final rinse. Do notpour
fabric softener directly on the wash load.
Select cycle and settings according to type, size, and soil level of
each load
See Operating Instructions for your specific model controls.
.
Start the washer.
Close the washer lid and pull out the cycle selector knob. The washer will
not fill with water, agitate or spin with the lid open.
,, To stop the washer, push in the cycle selector knob.
,, To change a cycle, push in the cycle selector knob. Turn it clockwise
to the desired setting. Pull out the knob to restart the washer.
10. Remove items when the cycle is completed.
For your safety, the lid locks when the tub is spinning. It will remain locked
for 2-3 minutes after the tub stops spinning.
,, To open the lid during a spin, push in the cycle selector knob and wait
about 2-3 minutes for the lid lock to release. Do not force open the
locked lid.
Place washed items in automatic dryer, line dry, or dry flat as directed by
fabric care label. Excess wrinkling, color transfer or odors may develop in
items left in the washer after the cycle has ended.
To avoid serious personal injury, do not operate washer if safety
lid lock is missing or damaged.
6