Craftsman 315.111810 Owner's Manual page 5

RULES FOR SAFE OPERATION (Continued)
Anextension cord should not b eused unless
absolutely necessary, Use ofimproper
extension cord could r esult inarisk offire and
electric shock. Ifextension
cord must be used,
make sure:
a. That pinson plug of extensioncord are the
same number, size and shape as those of
plug on charger.
b. That extensioncord is properly wired and in
good eiactdcalcondition; and
c. That wire size is large enough for AC
ampere ratingof charger as specified
below:
Cord Length(Feet) 25ft. 5Oft. 100ft. 150ft.
Cord Size (AWG) 16 16 16 14
Note: AWG = American Wire Gage
• DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged, have
replacedimmediatelyby a qualifiedserviceman.
Do not operate charger if it has received a
sharp blow, been dropped, or othen,#ise
damaged in any way; take it to a qualified
serviceman.
Do not disassemble charger; take it to a
qualified serviceman when service or repairis
required, Incorrectreassembly may resultin a
dsk of electric shock or fire.
To reduce risk of electdc shock, unplugcharger
from outlet before attempting any maintenance
or cleaning. Turning off controls will not reduce
this risk.
• Do not use charger outdoors.
• Disconnectcharger from power supplywhen
not in use.
SAVE THESE INSTRUCTIONS. Refer to them
frequentlyand use-them to instructotherswho
may use thistool, If you loan someone this tool,
loan them these instructionsalso,
_1= WARNING:
The operation of any power tool can result in foreign objects being thrown into your eyes,
which can result in severe eye damage, Before beginning power tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed, We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses
with side shields, avaiEable at Sears Retail Stores.
,_ WARNING: Do not allow familiarity with your
screwdriver to make you careless, Remember
that a careless fraction of a second is sufficient to
inflict severe injury.
,_ CAUTION: Your screwdriver contains special
high temperature batteriesto help prevent
battery damage when left on charge for extended
periods of time. However, once the batteries
become fully charged, we recommendthat you
unplug yourcharger from power supply and
disconnectit from scrswddver.
The fo ow ng recommended accessories are_urrently available at Sears Retail Stores.
No, 2 Phillips/ 8-10 Slotted,2 Ea.
No. 3 Phillips/ 6-8 Slotted, 2 Ea.
5-Pc. Hex Shank Drill BitSet
6-Pc. Extra Length Screwdriver Bit Set
"/-Pc. Screwdriver Bit Set and Case
13-Pc. Power Screwdriver / Nutdriver Set and
Case
30-Pc. Power Scrawddver/Nutdriver Set and
Case
17-Pc, Power Screwdriver/Nutdriver Set and
Case
_. WARNING: The use of attachments or accessories not listed mightbe hazardous,