Advertisement
•
Assemble the latch lock subassembly to the rear
tongue using two 1/4" x 3/4' hex bolts and 1/4"
(SEMS) type hex nuts. Tighten. See figure 2.
•
Assemble the plasfic cap to the front end of the rear
tongue as shown in figure 2.
*
Assemble the hitch bracket to the front tongue using
two 3/6" x 1" hex bolts, 3/8" Iockwashers and 3/8"
hsx lock nuts. Tighten. See figure 4;
•
Assemble the leg stand bracket to the front tongue
using two 5/16' x 1" hex bolts and 5/16" (SEMS) type
hex nuts, Tighten.
See figure 4.
I14" x 3/4"
HEX BOLT
LATCH LOCK
/
SUB-ASSEMBLY
/
REAR
TONGUE
114" HEX
',_
NUT (SEMS) /
PLASTIC CAP
LEG STAND
BRACKET
3/8" x 1"
HEX BOLT
5/16" x 1"
I
HEX BOLT
J
HITCH
_
BRACKET
I
8116" HEX
TONGUE
_%
WASHER
NUT (SEMS)
3/8" HEX
LOCK NUT
FIGURE 4
FIGURE 2
•
Assemble the axle and the rear tongue to the wheel
support with the open side of tongue facing away
from the wheel support. Fasten the axle to the wheel
support using two 1/4" x 1-1/2" hex bolts and two 1/4"
(SEMS) type hex nuts. Tighten. See figure 3.
Place the front tongue inside the rear tongue as
shown in figure 5. Fasten the tongues together using
a 3/8" x 4" hex bolt and a 3/8' hax lock nut. Tighten
without collapsing the sides of the tongue so that the
tongues can pivot freely, See figure 5.
•
Insert the 3/8" x 4" clevis pin through the tongues and
secure with a 1/8" hairpin cotter, as shown in figure 5.
1/4" x 1-1/2"
HEX BOLT
..,---" AXLE
REAR
.
\
_
TONGUE
WHEEL
SUPPORT
1/4" HEX NUT (SEMS)
FIGURE 3
FRONT
1/8" HAIRPIN
COTTER
FIGURE 5
LOCK NUT
jx,
CLEVIS PIN
3/8" x 4"
HEX BOLT
5
Advertisement
