Adjusting The Laser Line Projection; Using The Magnetic Base - Craftsman 320.48251 Owner's Manual

ADJUSTING THE LASER LINE PROJECTION (See Figure 5)
The laser line projected from
this tool can be adjusted 90 °
from vertical to horizontal and
all angles in between,
Use the black finger knob on
the top of the tool to adjust
angle,
1. Turn the tool on and be
careful not to point the tool
in the direction of
anyone's eyes.
2. Move the finger knob in
either direction to change
the angle of the laser line
on any surface directly in
front of the tool.
Fig. 5
USING THE MAGNETIC BASE (See Figures 6 and 7)
The Laser Trac
TM
Level has a magnetic base (see Fig. 6) that can be used with
either the Thin-Pin Wall-Mount Base or the Precision Leveling Base (see Fig. 7).
The magnetic base allows the tool to be mounted on any coated or uncoated
13/4x 4-in flat steel surface. This feature is particularly handy for working on steel stud
framework and duct_,_lork.For further instructions on the use of this tool with the
base plates see Using the Laser Trac
TM
Level section of this manual,
un,, i,lll,ll,,,,H,_, ............ i i,lll,ll i,llL,,, uH,,,,lln,,lll ,i,tl
Magnetic Base
Fig.
Fig. 6
6