GE Profile SmartDispense SPBD880 Installation And Owner's Manual page 11

ge.com
Cleaning the SmartDispense T"
Detergent and Fabric Softener
Tanks:
Detergent and fabric softener may build up
in the bottom of the $martDispense tanks
or on the fluid sensors. Residueshould be
removed before refilling tanks.
1. Open the pedestal drawer to the maximum
possible distance.
2. Pressthe tabs on the sides of the
instruction panel. SIowlg rotate the
instruction panel until it stops. Then, slide
the panel down in front of the tanks into
the slot available.
12.Open the tank cap and refillwith
the desired detergent or fabric softener.
13.Close the information panel and the
pedestal drawer.
14.Adjust the setting in the SmartDispense
menu if ang changes were made
to the concentration of the detergent
selected or to the location of the tank
that is being used.
°
o
°
°
Selectthe tank that gou wish to remove
for cleaning. Grasp the sensor at the rear
of the tank, using the grip provided, and
pull the sensor straight up.
Wipe the surface of the sensor,using
a moist cloth with a mild soap; then place
the sensor on the back surface of the
drawer or an adjacent tank.
Loosenthe supplg tube bg rotating
the fitting 90° until the tube can be pulled
straight up.
Wipe the surface of the tube and place it
on the back surface of the drawer or an
adjacent tank.
°
°
9.
Removethe tank bg tilting it slightlg toward
the washer and pulling straight up.
Rinsethe inside of the tank, using hot
water onlg to remove the residue.
Oncethe tank has been rinsed thoroughlg,
replace the tank in the drawer before
refilling the tank.
10. Reattach the supplg tube bg inserting it
into the tank and tightening the fitting
bg rotating toward the back.
11. Replace the sensor bg inserting it into
the tank in its original position.
11