Glass Cooktop - GE JBS03 Owner's Manual And Installation Instructions

Cleaning the glass cooktop, rot, some modes
Clean gour cooktop after
each spill. Use CERAMA
BRVTE ® Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuse CEBAMABBYTE ® Ceramic Cooktop
Cleaner on the glass cooktop. Other creams
mag not be as effective.
To maintain and protect the surface of gour
glass cooktop, follow these steps:
[] Before using the cooktop for the first
time, clean it with CERAMA BRYTE ®
Ceramic Cooktop Cleaner This helps
protect the top and makes cleanup
easier
[] Dailg use of CERAMA BRYTE ®Ceramic
Cooktop Cleaner will help keep the
cooktop looking new.
[] Shakethe cleaning cream well. Applg a
few drops of CERAHABRYTE ¢ Ceramic
Cooktop Cleaner directlg to the cooktop,
[] Use a paper towel or CERAHABRYTE ®
Cleaning Pad for Ceramic Cooktops to
clean the entire cooktop surface.
[] Use a drg cloth or paper towel to
remove all cleaning residue. No need
to rinse.
NOTE: It is very important that b!ouDO NOT
heat the cooktop until it has been cleaned
thoroughl£.
X X X X x
_illi_i _ii _ii _ii_ i_ _k _
Use a CERAMA BRYTE ® Cleaning
Pad for Ceramic Cooktops.
Burned-On Residue
WARNING: DAMAGE to b!our gloss surface
mob/occur if b!ou use scrub pods other than
those recommended.
[] Allow the cooktop to cool.
[] Spread a few drops of CERAMABRYTE ®
Ceramic Cooktop Cleaner on the entire
bumed residue area.
[]
Using the included CERAHABRYTE ¢
Cleaning Pad for Ceramic Cooktops, rub
the residue area, applging pressure as
needed.
[] If ang residue remains, repeat the
steps listed above as needed.
[] For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE ¢
Ceramic Cooktop Cleaner and a paper
towel.
The CERAMABRYTE ® Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts Center.
See instructions under "To Order
Parts" section on next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
[] Allow the cooktop to cool.
[] Use a single-edge razor blade scraper
at approximatelg a 45° angle against
the glass surface and scrape the soil.
It will be necessarg to applg pressure
to the razor scraper in order to
remove the residue.
[]
After scraping with the razor scraper,
spread a few drops of CERAHABRYTE ®
Ceramic Cooktop Cleaner on the entire
burned residue area. Use the CERAMA
BRYTE ¢ Cleaning Pad to remove ang
remaining residue.
[] For additional protection, after all
residue has been removed, polish the
entire surface with CERAMA BRYTE ®
Ceramic Cooktop Cleaner and a paper
towel.
32