Advertisement
Before you call for service...
Troubleshooting -tips
PossibleCauses
What ToDo
Washerdidnotfill to
Extremely
low war er pressure
•
Pressthe STARTbuuonagain.
chosenlevel
Inlet hoses are kinked
" Straighten hoses.
Water valve screens are
• Turn offthe water source and renlove the water connection
stopped up
hoses from the upper back ot the washer. Use a brush or
toothpick to (:lean the screens in the machine. Reconnect
the hoses and mrn the water back on.
"
3("
Waterfills and drains
Drain stand pipe is too low
Drain stand pipe must be above,
).
at thesametime
PossibleCauses
What ToDo
Washer is noisy
Washer is uneven
" To level the fi'ont of the washer, a_!just the flont leveling
legs by rotating the individual leg in tile proper direction
fi)r up or down. To level back of washer, lift back of
machine 4" (l I cm) and sel down.
Washer load is
" l'ress PAUSEIo stop/lie washer, open/he
lid and
unbalanced
redisuibu/e/lie
h)ad evenly. Close tlle lid and press
START.
Shipping rod is still assembled
" To remove shipping rod from washer, pull yellow tag mad
in unit
a/lathed
rod flom/lie
bol/Olll
righ/hand
side of washer.
Washer is sitting too close
" Pull washer aw:ty fiom/lie
wall; abou/4"
( 11 (m)
to wall (causes knocking
is needed.
during cycle )
Possible Causes
What ToDo
Labels on the exterior
Occasionally the adhesive
of the washer will not
used on the labels does
peel off cleanly
not release cleanly
" Use a hair (hTer set at the lowest heat setting, (firecting
the _firat the label ti)r a short amount of time. This will
release the adhesive easily, '_4thout damaging the surlilce
ofthe washer.
12
Advertisement
