Control; Pad Models - GE AGL24 Owner's Manual And Installation Instructions

About the controlson the air conditionermmodels with touchpads.
Features and appearance will vary.
(;eel on
Fan on
Energy
Saveror
Air ConditionerControls RemoteControl
Controls
o ON/OFFPad
TtlFns aiI" (-onditionei" on and of].
Oisplav
Shows the set temperature or time remaining
on
timer.
O MODE
Use to set the air conditioner to COOL or
FANmode.
O Increase •/Decrease • Pads
Use to set temperature when in COOL mode.
O AN Pad
Use to set the tm_ speed to LOW(FI),MED (F2)
or HIGH(1:3).
O NERGYSAVER--Conm_ls
the tim.
(on some models)
O/_-The tim and compressor cycle on and
oil This results in wider \m'iations of room
temperature and humidity. Nommlly used
when the room is unoccupied.
Note: Thefan
will continue to run for a short time after the
compressorcycles off
OFF
The tim runs all the time, while the
COI/II)I'eSSOI" cycles
on and ott_
This teattli'e must be set at
OFFin
order to use
the tan settings (on the mode control).
Note: On some models,the ENERGY SAVER
feature cannot be set on the air conditioner.
It must be set
using
the remote control
O CIRCUUIIRE (on some models)
FoI" con[intiotis
side-to-side air
ciI'('tIlation
(cool settings only), set the Circulaire switch
to
ON.
For fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then turn it OFF.
O TIMER Pad
ON--_._qmn the air conditioner is off, it can be
set to automatically come on in 1 to 12 horus
at its i)revious setting. Each touch will set the
timer in hotu_.
OFF
"X._q_en the air conditioner is on, it can be
set to autoinaficallv turn off in 1 to 12 houI_.
Each touch will set the timer in horns.
Tocancel the timer, press the TIMERpad until
the displa) time disappeai_.
O Remote Control Signal Receiver
4
Remote Control
iJi:: T o ensure proper operation, aim the
remote control at the signal receixer
on the air condifionei:
iJi:: T he remote control signal, has a range, of uI)
to 21 teet.
::Ji:: Make sure nothing is between the air
conditioner and the i'eil/ote control
that could block the signal.
::Ji:: Make sure batteries are ti'esh and installed
correctly as indicated on the remote control.