Hitachi L40C205 Owner's Manual page 20

Connections to other equipment (continued)
To connect a HDMI or a DVI device to the unit
The HDMIiDVI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital video from a DVI
device.
When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate analog audio cables are
required.
Back of the unit
RGBiDVI AUDIO Input
1
i RGB _ HDMTIiDVI
RGBiDVI HDMI2
AUDIO
Audio cord (not supplied)
To DVI output
HDMI - to - DVI adapter cable
(HDMI type A connector) (not supplied)
To HDMI/DVI IN or
HDMI cable (type A connector) (not supplied)
To HDMI out
DVI device
HDMI device
When using a HDMI input from a Set-Top-Box, it is recommended to use a 1080p, 1080i or 720p input signal.
When the HDMI input is a 1080p signal, it is recommended that the length of the cable should be less than 5 meters.
Using an AV Amplifier with built-in digital surround
If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including Dolby Digital Surround
audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, DTS decoder, or MPEG decoder etc. as shown below.
Rear of the unit
®
DIGITAL
AUDIO OUT
COAXIAL
To
COAXIAL OUT
Coaxial digital cable---_
(not supplied)/
To Coaxial_ I
Digital Audio Input'xi
oo_ o o o EEl
AVAmplifier with built-in digital surround I '
decoder as listed above
Front Speaker
Subwoofer (Right)
TV
Front
Speaker
(Left)
_ Sp_°l_en#(Right)
• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio. There will be no sound
output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.
20