Remote Control; Antenna Connections - JVC TV-13140 User Manual

REMOTE CONTROL (CONTINUED) ANTENNA CONNECTIONS
BATTERY INSTALLATION
H Slide the pattery compart-
ment cover in the direction
of the arrow.
Install two =AA" (penlight size) batteries, paying
attention to the poladty
diagram in the battery compartmenL
Replace the compadment
cover,
BATTERY PRECAUTIONS
r
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified,
2. Be sure to follow the correct pufadty when installing the batteries as indicated in the battery comparirnent.
Reversed bederies may cause damage to the device.
3. Do not mix different types of battebes together (e.g. Alkaline and Carbon-zinc) or old pettebes with fresh
ones,
4, If the device is not to be used for a long period of time, remove the baifer;es to prevent damage or injury
from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Folk_w
battery manufacturer's directions.)
EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER
• 0
NOTE: • When them is an obstacle between the TVNCR and the transmitter, the transmitter may not operate.
• When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light shines on the
Remote sensor of the TV/VCR, the remote operation may be unstable.
If you are using outdoor antenna (outdoor antenna not included), follow the instructions below that
commpond to your antenna system, If you are using a cable TV service (CAW), see page 13 for Cable
"IV connections.
Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire)
Connect the 75 ohm cable from the combination VHF/
I UHF antenna to the antenna jack.
If your combination VHF/UHF antenna has a 300 ohm
_A_IONHGM_ twin-lead wire, the use of the 300-75 ohm matching
transformer may be necessary,
75 OHM
COAXIAL
CABLE
TRANSFORMER
(not included)
Combination VHF/UHF Antenna (Separate VHF and UHF 300 ohm twin-lead wires)
• Connect the UHF 300 ohm twin-lead wire to the
OHM
MATCHING
TRANSFORMER
(not included)
VHF 300 ohm
COMBINER
(not included) UHF 300 ohm
combiner (not supp4ied), Connect the VHF 300 ohm
twin-lead wire to the 300-75 ohm matching trans-
former, Attach the transformer to the combiner, then
attach the combiner to the antenna jack.
Separate VHF/UHF Antennas (75 ohm VHF cable and 300 ohm UHF twin-lead wires)
Connect the VHF 75 ohm e_,ble and UHF 300 ohm
twin-lead wire to the combiner. Attach the combiner
COMBINER to the antenna jack.
(not included)
10 11