Avoid Service Checklist - Frigidaire Gallery Owner's Manual

Avoid Service Checklist (continued)
OCCURRENCE POSSIBLE CA USE / SOL UTION
Oven light does notwork. Burned-out or loose bulb. Follow the instructions under Changing Oven Light to
replace or tighten the bulb.
Oven smokes excessively during
broiling.
Oven door is closed. Door should be open during broiling.
Meat too close to the broiler unit. Reposition the rack to provide more clearance
between the meat and the broiler. Preheat broil element for quick searing operation.
Meat not properly prepared. Remove excess fat from meat. Slash remaining fatty edges
to prevent curling, but do not cut into the lean.
Grid on broiler pan wrong side-up. Greasedoes not drain into broiler pan. Always place
the grid on the broiler pan with the ribs up and the slots down to allow grease to drip
into the pan.
Broiler pan used without grid or grid cover with foil. DO NOTuse the broiler pan without
the grid or cover the grid with foil.
Oven needs to be cleaned. Grease has built up on oven surfaces. Regular cleaning is
necessary when broiling frequently. Old grease or food spatters cause excessive
smoking.
Poor baking results. Many factors affect baking results. See Baking for hints, causes and corrections. See
Adjusting Oven Temperature.
Self-cleaning cycle does not work. Make sure the oven door is close.
Controls not set properly. Follow instructions.
Self-cleaning cycle was interrupted. Stop time must be set 2-4 hours past the start time.
Follow steps under "To Stop or Interrupt a Self-Cleaning Cycle" in the Timer Control
Guide.
Soil not completely removed after self-
cleaning cycle is completed.
Flames inside oven or smoke from
vent.
Oven door (side swing model) is too
loose or too tight to open.
On a dual cavity model, one oven is in operation. If one oven is set for any mode, the
second oven cannot be set to CLEAN.
Failure to clean bottom, from top of oven, frame of oven or door area outside oven seal.
These areas are not in the self-cleaning area, but get not enough to burn on residue.
Clean these areas before the self-cleaning cycle is started. Burned on residue can be
cleaned with a stiff nylon brush and water or a nylon scrubber. Be careful not to damage
the oven gasket.
Excessive spillovers in oven. Set the self-clean cycle for longer cleaning time.
Excessive spillovers in oven. This is normal, especially for high oven temperatures, pie
spillovers or for large amounts of grease on bottom of oven. Wipe up excessive
spillovers.
There is an oven door bracket on your model. Follow the instructions under "Oven Door
Bracket Adjustment".
11