Installation
Instructions
(cont'd)
Installation
Checklist
• Whether or not the element conversion is made, the model
rating plate must be marked. Using a hard point ink pen,
check the appropriate block within the model rating plate,
which is located adjacent to the lower access panel.
•
Is the fuse or circuit breaker size correct as shown in the chart
in the "Product Specifications" section?
•
Are the wires from the circuit
breaker or fuse service to the
water heater's junction
box on the correct wire size (gauge) as
shown m the chart in the "Product
Spec'fications"
section?
Is the new temperature-pressure
relief valve properly
installed, and piped to an adequate drain? See "Temperarure-
Pressure Relief Valve" section.
•
Is the water heater completely filled with water? See "Filling
the Water
Heater"
instructions
in the "Installation
Instructions" section.
Will a water leak damage anything? See _Facts to Consider
About the Location" section.
•
Are the cold and hot water lines connected
to the water heater
correctly?. See "Water Piping" instructions in the "Installation
Instructions"
section.
•
Is there adequate clearance for maintenance
around the water
heater?
• Do you need to call your electric company to check your
wiring?
HOT
/[]
COLD
TEMPERATURE-
JPRESSURE
RELIEF VALVE
F---DISCHARGE
PIPE
(Do no_ cap or
plug)
6 "AIR
GAP
FLOOR DRAIN
MODEL RATING PLATE
15