Kenmore 2539753111 Owner's Manual page 4

Unstailation
(continued)
Installing Dial Plate and Front Frame
Some models require installation of the dial plate and the front panel of the air
conditioner, To assemble the unit, follow these steps
STEP I:
REMOVE PANEL FROM FRONT FRAME:
==========================================
Ao Pull top of panel away from front frame
Panel
B, Pull bottom of panel straight out and away from front frame
INSTALL DIAL PLATE AND BUTTONS OR KNOBS: If dial plate
has clear protective film, peel off carefully Do not scratch
surface
STEP 3:
CONNECTING FILTER MONITOR FEATURE, On models with
the Filter Monitor feature, install the dial plate as shown above,
then fully extend the plastic tube and clip in the condenser coil,
centered from top to bottom_
1
Unit
Flange_
INSTALL FRONT FRAME TO UNIT.
A Align bottom frame flanges onto
springs (some models), and press
down as you push in frame flanges
on the top of frame, into the unit
Sprincj
Depending on your model, fasten front retaining
screws on both sides of unit, or fasten screws to
unit through holes in frame,
If the unit has a screw in this location,
remove and discard before installing front