Seabd Burner Modeb - Kenmore ELITE 790.3323 Series Use & Care Manual

Genera Care & C eaning
Sealed Burner
To C_ean the Burner Grates, Countoured Burner Skirts (some modeJs), Burner Caps and Burner Heads
The burner grates, contoured burner skirts (some models), burnercaps and burner head should be routinelycbaned, Keeping
the burner ports dean will prevent improper ignition and an uneven flame, See instructions below,
To Clean the Burner Grates
Be sure burners and grates are cooJ before you place your hand, a potholder, cleaning
cloths or other material on them, The cast iron burner grates can be washed in hot soapy
water, Rinse thoroughly and dry the grates with a cloth; don't put them on the cooktop while
still wet, Be sure the grates are positioned securely over the burners,
To remove burned on food, place the g rates in a covered container or plastic bag, Add 1/4
cup ammonia and soak for 30 minutes, Wash, rinse well and dry, An abrasive cleaner can
be used for stubborn stains,
To Ctean the Contoured Burner Skirts (some modeJs)
Burner grate can appear in
different shapes,
The burner skirts are attached to the cooktop and are not removable, The burner skirts forms a recessed well area located
around each burner unit, if spill occurs in one of the well areas, turn off burner and blot up spill with an absorbent cloth, Rinse
with a clean, damp cloth and wipe dry,
Burner Cap
Burner Skirt
(some models
Electrode
Sealed Burner
To Cban the Burner Cap
Remove burner cap, Use soap-filled pad or mild abrasive cleanser to clean ::
burner caps, if necessary, cover stubborn spots with an ammonia-soaked {
...... /
paper towel for 30 minutes, Rub gently with a mixture of clean water and
vinegar, Wipe dry, Remove all cleaners or the porcelain may become
damaged during future heating,
To Clean the Removable Burner Head and Gas Opening (some modets}
The ports (or slots) around the burner head must be routinely cleaned, Use
a smalPgauge wire or needle to clean small slots or holes,
Note: if the electrode is damaged or broken, the surface burner wiii not light
because it will not spark, Manual fighting with a match is still possible,
For proper flow of gas and ignition of the burner =DO NOT ALLOW SPILLS,
FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE
GAS OPENING TUBE, Gas must flow freely through the small hob in the
brass orifice for the burners to fight properly, if the gas opening orifice
becomes soiled or clogged, use a small=gauge or needle to clean, ALWAYS
keep the burner cap in place whenever a surface burner is in use,
To Reptace the Burner Head and the Burner Cap
Make sure the pieces are thoroughly dry before placing back,
1, Replace burner head and burner cap in their places, Make sure each
burner cap and burner head are properly aligned and leveled,
2, Replace the burner grate,
3, Turn the burner on to determine if it fights, if the burner does not light after
cleaning, contact an authorized servicer, Do not service the sealed burner
yourself,
lS