Getting Started; Remote Control; System; Step 2: Setting The Clock - Philips MX3950D Owner's Manual

Getting Started
Step 1: Inserting batteries into
the remote control
@ Open the battery compartment
Insert two batter es type R06 or AA, following
the indications (q- --) inside the compartment
Close the coven
Step 2: Setting the clock
The dock can be set ir_either 12hour or
24 hour mode C 12DO FI...... _ "
example)
buttons on DVD system's
front panel display panel
_ cc_ FT Cl nc , n}_
@ Aim the remote cont/-ol directly ........ _ @
at the remote sensor (iR) o_ the
front panel
cor,tro by pressing one of the
source select but*ons on the
remote control (fur example
TV/AV, TUNER)
Then se}ect the desired funct on
(forexample • II, 141_1, I_1_1)
wm m
_},," }>,,
CD_CD
i
CAUTION!
- Remove batteries if they are
exhausted or if the remote is not to be
used for a long time.
- Do not use old and new or different
types of batteries in combination.
- Batteries contain chemical substances,
so they should be disposed of properly.
@
@
@
@
@
Press STANDBY ON to switch on the DVD
system
Press and hold CLOCK,TIMER ur,til
"SELEET ELOEP, _,_;i T ?IEFiI, appears
Press I_1_ (if necessary) to change the disp ay
to "_LrjL£ ,", then press CLOCK'TIMER a@aln
to con@m
Press1411411 / I_l)q to set the minutes and hours
To ncreasethe speed,hold down 14141 or I_1_1
,_ The changesin minutes will roll over to the
hours
PressPROG to change between 12hour and
24 hour clock mode
Press CLOCK,TIMER again to store the
setting
_¢ The dock will starl work ng
To view the clock time in any active
mode
PressCLOCK,TIMER
_¢ T_e cock will d splay f_r a few secords
Notes;
I_ the DVD system is @sconnected f_om tl,e
power supply, it will etose the clock sett_Pg
I[ you do not p_ess any buttons within 90
seconds, _he system will exit clock setting mode
18
pg 001 044 MX39 37 Engl 18 2/25/03, 10:28 AM 3139
115 21993