Dell Broadcom NetXtreme Family of Adapters User Manual page 189

User Diagnostics: Broadcom NetXtreme II Network Adapter User Guide
<ncsi_image>
uxdiag -fnvm
<raw_image>
uxdiag -fump
<ump_image>
uxdiag -help
uxdiag -I <iteration
num>
uxdiag -idmatch
uxdiag -log <file>
uxdiag -mba <1/0>
uxdiag -mbap <n>
uxdiag -mbas <n>
uxdiag -mbav <1|0>
uxdiag -mbavval <n>
uxdiag -mfw <1/0>
uxdiag -t
<groups/tests>
uxdiag -T
<groups/tests>
uxdiag -ver
uxdiag -wol <1/0>
Table 2: uediag Command Options
Command Options
uediag
uediag -c <device#>
uediag -cof
uediag -dev <device#> Specifies the adapter (device#) to test.
uediag -F
uediag -fbc
<bc_image>
uediag -fbc1
<bc1_image>
uediag -fbc2
<bc2_image>
uediag -fl2b
<l2b_image>
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/userdiag.htm[9/26/2012 3:29:54 PM]
Specifies the bin file to update the NCSI firmware.
Programs the raw image into NVM.
Specifies the bin file to update UMP firmware.
Displays the Broadcom NetXtreme II User Diagnostics (uxdiag) command options.
Specifies the number of iterations to run on the selected tests.
Enables matching of VID, DID, SVID, and SSID from the image file with device IDs. Used only with
-fnvm <raw_image>.
Logs the test results to a specified log file.
Enables/disables Multiple Boot Agent (MBA) protocol.
1 = Enable
0 = Disable
Sets the MBA boot protocol.
0 = PXE
1 = RPL
2 = BOOTP
3 = iSCSI_Boot
Sets the MBA/PXE speed.
0 = Auto
1 = 10H
2 = 10F
3 = 100H
4 = 100F
6 = 1000F
Enables/disables MBA VLAN.
1 = Enable
0 = Disable
Sets MBA VLAN (<65536).
Enables/disables management firmware.
1 = Enable
0 = Disable
Disables certain groups/tests.
Enables certain groups/tests.
Displays the version of Broadcom NetXtreme II User Diagnostics (uxdiag) and all installed adapters.
Enables/disables Magic Packet WOL.
1 = Enable
0 = Disable
Description
Performs all tests on all Broadcom NetXtreme II adapters in your system.
Specifies the adapter (device#) to test. Similar to -dev (for backward compatibility).
Allows tests to continue after detecting a failure.
Forces an upgrade of the image without checking the version.
Specifies the bin file to update the bootcode.
Specifies the bin file to update bootcode 1.
Specifies the bin file to update bootcode 2.
Specifies the bin file for L2B firmware.