Belt Changing And Agitator Cleaning; To Remove Belt; To Clean Agitator; Agitator Assembly - Kenmore Power-Mate KC50XBZRZU01 Owner's Manual

TO REMOVE BELT
1. Turn Power-
Mate ® upside
down.
2. Unscrew the
two (2) Power-
Mate® cover
screws.
3, Turn Power-
Mate® right side
up. Press handle
release pedal
and lower the
swivel, Lift rear
latches up.
Latch Latches
4. To remove cover,
grasp the sides and
pullout.
5. Lift agitator
assembly out
and remove
worn belt.
'<------- Base
End Cap
6. Check and clean end cap areas. See
AGITATOR ASSEMBLY forpictureof
complete agitator assembly.
TO CLEAN AGITATOR:
NOTE: in order to keep cieaning efficiency
high and to prevent damage to your vacu-
um, the agitator must be cleaned every_ time
the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Use Clean Agitator
HEAVY - every week
(used daily)
MODERATE - every month
(used2-3 times/week)
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Disconnect cleaner from electrical outlet.
Check and remove hair, string and tint buiJd-
up frequently in the Power-Mate® agitator
and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, or end caps.
Agitator Assembly
Belt Pulley_
Brush Unit
1o