Whirlpool DU920QWDB5 Use And Care Manual page 19

NOTE: A special a dapter m ustbeinstalled
onthefaucetbefore thedishwasher canbe
connected. Complete i nstructions a ndthe
adapter a repacked withyourdishwasher.
Whenmoving yourdishwasher make sure
thedooris latched. H old thedishwasher at
thetopfrontcorners,
NOTE: M akesurethehosesarenot
kinked or twisted. K inked hoses reduce
washing performance.
Connecting the dishwasher
1. waterRUn wateroff, at faucet until it is hot. Turn ll'__l
2. Pull hoses out of their storage compart-
ment on the back of the dishwasher.
3. Pull down on the locking collar while
lifting the hose connector onto the faucet
adapter.
4. When the connector snaps into place,
release the locking collar.
& Turn the hot water on slowly until it is all
the way on.
6. Plug in power supply cord.
7. See the "Starting a wash cycle" section
for instructions on how to start the
dishwasher,
Locking collar
Hose connector
Drawing water when dishwasher is
connected
You can draw water from the faucet while
the dishwasher is connected. Do not draw
water while the dishwasher is filling or while
water is being pumped out. (This helps
prevent a low fill when dishwasher is filling
or mixing drain water with fresh water,)
* Press the red button on the hose connec-
tor to draw water from faucet. (The faucet
is set on hot. Adjust faucet for the water
temperature you want.)
NOTE: Turn hot water back on after you
draw water from faucet. Turn off cold water.
19