Confirming The Measurement Result - Yamaha RX-V471 Owner's Manual

Optimizing the speaker settings automatically (YPAO)
Confirming the measurement result
Confirm the YPAO measurement result.
After measurement, press the cursor keys to select
"Result," and then press ENTER.
The following display appears.
Cursorkeys
ENTER
RETURN
Red-boxed message indicates a speaker that has a problem.
@ Measurement items
@ Measurement result for each speaker
2
Press the cursor keys (A/v) to select an item.
The red-box indicates the speaker that has a problem in the
following items. For details on remedy of each problem, refer to
"Warning messages" (p.30).
Wiring
Displays the condition of the polarity of each connected
speaker.
"Normal": Speakers are connected at the normal polarity. (+
and -)
"Reverse": Speakers are connected at the opposite side of
normal polarity. (+ and -)
Size
Displays the size of the connected speakers.
"Large": The connected speaker has the ability to
reproduce the low-frequency signals effectively.
"Small": The connected speaker does not have the ability to
reproduce the low-frequency signals effectively.
The value displayed above "SWFR" describes the cross over
frequency of the subwoofer.
Distance Displays the distance between connected speakers and the
listening position.
Level Displays the result of the adjustment of output level of
connected speakers.
3
• The speaker indicated with red box shows that it may have a certain
problem. Check the connection or placement, and if necessary, perform
YPAO again referring 'Warning messages" (p.30).
To return the previous screen after confirmation,
press ENTER or RETURN.
• (If no problem with the result) Press the cursor key (V)
to select "Save / Exit" and ENTER, and then confirm that
"SAVE" is selected and press ENTER to finish the YPAO.
• (If some problem with the result) Press the cursor key
(V) to select "Save / Exit" and ENTER, and then press
the cursor key (D) to select "CANCEL" and ENTER. To
restart the YPAO measurement, select "Start." To finish
the YPAO, select "Exit."
En 28