Product Specifications - Hitachi B13F Instruction Manual

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals
known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals, work in a well-ventilated area and work with approved safety equipment such as dust masks that are
specially designed to filter out microscopic particles.

PRODUCT SPECIFICATIONS

MOTOR
Power Source...................115 V, 60 HZ, 3.5 AMPS.
Speeds.............................5 - 680~3000 RPM
Horsepower......................1/3 HP (Continuous Duty)
Capacity
Chuck Size.......................1/2"
Spindle Travel...................2 1/2"
Throat ..............................5"
Table
Size ..................................7 13/16" x 7 13/16"
Tilt ....................................45° Right or Left
Dimensions
Base Size.........................8 1/16" x 13 3/16"
Height ..............................28"
NET WEIGHT............................61 LB (27.5 kg)
WARNING
(Revolutions Per Minute)
SAVE THESE INSTRUCTIONS
To avoid electrical hazards, fire hazards, or damage to the
tool, use proper circuit protection.
Use a separate electrical circuit for your tools.
Your Drill Press is wired at the factory for 115V operation.
Connect to a 115V, 15 AMP branch circuit and use a 15 Amp
time delay fuse or circuit breaker. To avoid shock or fire,
replace power cord immediately if it is worn, cut or
damaged in any way.
– 3 –
WARNING
English