Basic Operations; S Witching P Ower On/Off; Djusting The V Olume; S Electing A Z One And C Hannel /G Roup Id - Kenwood NEXEDGE NX-700 Instruction Manual

S p on/oFF
wiTching ower
Press and hold the
power ON. Press and hold the
■ Transceiver Password
If the transceiver is password protected, "PASSWORD" will appear on the
display when the power is turned ON. To unlock the transceiver, enter the
password:
1 Select a character using
• If you are using a microphone keypad, you can enter the password direclty.
2 Press to enter the selected character.
• This step is unnecessary when using the keypad.
3 Repeat steps  and 2 to enter the entire password.
• Press
characters.
4 Press or
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
• The password can contain a maximum of 6 digits.
A v
djuSTing The olume
Press the keys programmed as Volume Up/ Volume Down to adjust the volume.
S Z
elecTing A one And
Select the desired zone using
channels.
Select the desired channel/group ID using
is programmed with settings for transmitting and receiving.
• You can toggle the display between the zone and channel/group ID names and number
by pressing the key programmed as Display Format, or by accessing the Menu {page 9}.
Note: If the default settings for
select the zone and channel/group ID.
T
rAnSmiTTing
1 Select the desired zone and channel/group ID.
2 Press the key programmed as Monitor or Squelch Off to check whether or
not the channel is free.
• If the channel is busy, wait until it becomes free.

BASIC OPERATIONS

switch for approximately  second to turn the transceiver
switch again to turn the transceiver OFF.
/ .
or # to delete a character. Press and hold
to confirm the entry.
c /g
hAnnel roup
/
/ and
id
(default). Each zone contains a group of
/ (default). Each channel/group ID
/ have been changed, use the appropriate keys to
or # to delete all
7