Care And Cleaning; Control Panel; Knob; Lift-Off Oven Door - GE JKP30 Owner's Manual

Care and cleaning of the oven. GEAppliances.com
Be sure electrical power is off and all surfaces are cool before cleaning any part of the oven.
How to Remove Protective Shipping Film and Packaging Tape
Carefully grasp a corner of the protective
shipping film with your fingers and slowly peel
it from the appliance surface. Do not use any
sharp items to remove the film. Remove all of
the film before using the appliance for the first
time.
To assure no damage is done to the finish
of the product, the safest way to remove
the adhesive from packaging tape on new
appliances is an application of a household
liquid dishwashing detergent. Apply with a soft
cloth and allow to soak.
NOTE: The adhesive must be removed from all
parts. It cannot be removed if it is baked on.
Control Panel
It'sa good idea to wipe the control panel after
each use. Clean with mild soup and water or
vinegar and water, rinse with clean water and
polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleansers, plastic scouring pads or oven
cleaners on the control panel-they will
damage the finish. A 50/50 solution of vinegar
and hot water works well.
Control Knob
(on some models)
The control knobs may be removed for easier
cleaning.
Hake sure the knobs are in the OFF positions
and pull them straight off the stems for
cleaning.
The knobs can be cleaned in a dishwasher or
they may also be washed with soap and water.
Hake sure the inside of the knobs are dry
before replacing.
Replacethe knobs in the OFF )osition to ensure
proper placement.
Slot
Pull hinge locks down ta unlock
Removal position
Lift-Off Oven Door
The door is very heavv. Be careful when []
removing and lifting the door.
Do not liftthe door by the handle.
To remove the door'.
[Z] Fully open the door.
r_ Pullthe hinge locks down toward
the door frame, to the unlocked position.
A tool, such as a small
flat-blade screwdriver, may be required.
Firmly grasp both sides of the door at the r_
r_ top.
[] Close door to the door removal position,
which is halfway between the broil stop r_
position and fully closed.
Lift door up and out until the hinge arm is
clear of the slot.
To replace the door'.
Firmly grasp both sides of the door at the
[Z] top.
With the door at Bottom
the same angle edge
of
as the removal slot
position, seat the
indentation of the
hinge arm into
the bottom edge
of the hinge slot.
The notch in the
hinge arm must be fully seated into the
bottom of the slot.
Hinc e arm
Fully open the door. If the door will not
fully open, the indentation is not seated
correctly in the bottom edge of the slot.
Pushthe hinge locks up against the front
frame of the oven cavity, to the locked
position.
Hinc
arm
Hing
Push hinge lacks up to lock
r_ Closethe oven door.
23