Related Manuals for Haier Tiana HW1007NZP
Summary of Contents for Haier Tiana HW1007NZP
- Page 1 Automatic Drum Washer-dryer HW100-HB1297NZP User Manual Please read these instructions carefully before use. Please save these instructions for future reference.
-
Page 2: Specifications
Product Features DD inverter frequency motor technology Function (Stop just in time upon cleanness) Hybrid balance technology Drawer-type box Inclined drum Function of Supporter Dry Large capacity Self-cleaning function Optimal door height design Air-wash function Large-caliber clothes-loading opening Technology of anti-bacteria and mildew-proof with JIT function (Stop just in time upon window pad drying) -
Page 3: Table Of Contents
Contents 15 Fault Diagnosis and Solution Safety Precautions Displayed Code meaning Solution Precautions for Use code Components The washer is in automatic weighing state Normal prompt Accessories Notice before Use Code for the clothes weight: Control Panel and Program Description X=1(i.e. -
Page 4: Safety Precautions 1
1 Safety Precautions State Phenomenon Solution Electrical safety prompt: Check the detergent for proper type and dosage Please pay attention to electrical safety during use. Poor washing effect Check whether a proper program is selected The plug should be accessible after the washer-dryer is installed in place. Do Check whether the clothes weight exceeds the washer-dryer’s When not disconnect the plug from the socket by pulling the power cord. -
Page 5: Fault Diagnosis And Solution
15 Fault Diagnosis and Solution 2 Precautions for Use 1.Due to the fluctuation of water pressure, please check all the joints of water inlet pipe, water tap and drain The following phenomena are not necessarily faults of the washer-dryer. Please check against the following table before call for servicing. - Page 6 To clean the drying filter box 15. When washing small articles (e.g. handkerchiefs, gloves, socks, etc.) and those clothes liable to inter-twist and wear, please put them in net bags for washing, rinsing and spinning to prevent them from Note: Please clean the drying filter box after using the drying function every time. falling into between the inner drum and window pad and further avoid inadequate washing and drying.
-
Page 7: Components
3 Components 14 Cleaning/Maintenance Please unplug the power plug from the socket before cleaning and maintenance. Main control panel Drying filter box Tabletop pannel After finishing washing, please turn off the water tap and remove the water inlet pipe. Unplug the power plug and put back the drain pipe. If the washer-dryer is not to be used for a long time, please keep the door slightly open and dry the Distributor window pad to avoid unpleasant smell. -
Page 8: Accessories
HAIER WARRANTY HAIER APPLIANCES (INDIA) PVT. LTD. (hereinafter referred to as “the company”) hereby offers the following warranty to the original domestic purchaser commencing from the date of the purchase. The company will, free of charge repair or replace any defective part or parts which prove to be defective in workmanship and/or materials and not due to abnormal or improper usage at its sole discretion. - Page 9 (3) Install the water inlet pipe joint 13 Other Functions Wall If the water tap is placed Loosen the nut to the extent that approximate 3-4 turns of against the wall, you may Power-down memory screw thread are exposed; turn this screw to a proper positio in advance Loosen four screws of the water inlet pipe joint to the extent With the power-down memory function, the washer-dryer can memorize the program’s running state...
-
Page 10: Preparations Before Washing
To connect the drain pipe 11 Preparations before Washing Floor drainer Drain outlet Ring the drain pipe on the joint; Pipe clamp Check the articles to be washed for special washing requirements and make sure that they are Pipe sleeve Fix the pipe clamp to the groove of drain pipe;... - Page 11 10 General Program Running Distributor box Please select suitable non-foaming or low-foaming washing powder/detergent for automatic drum washer; Process As for the dosage of detergent, please refer to the instructions for detergent. Excessive detergent may result in too many bubbles and spill as well as affect its dissolution; The level of softener or liquid detergent must not be higher than the “MAX”...
-
Page 12: Control Panel And Program Description 9
6 Control Panel and Program Description 9 Operational Procedures Press the “ Wash ” button to set Display washing program, After setting relevant parameters, washing time. washing time, remaining press the “Start/Pause” button time,delay time,times of once, the selected program will Note: Washing time doesn’t Connect the Insert the... - Page 13 8 Programs Guide After turning on the washer-dryer,select the desired washing program by turning the knob.Press any function button (e.g. “Speed”, “Temp.”, “Delay”, “Dry”, “Spin”, “Rinse”, “Wash” button ) once and turn the program knob within 3s to set televant parameters. After turning on the washer-dryer,the “Spin”...
- Page 14 Note: The time displayed on the display screen is only for reference and may be slightly different from the 7 Display Screen actual time. It illuminatcs when the “Delay” function is selected. It illuminates Mark of locking door Prompt information After selecting the “Delay”...