JVC VN-H37U series Operation Manual page 16

No. Item
⑤
Alarm Settings
Trigger1
Interval
(VN-H57U/H2
57U/H257VP
U/H157WPU
only)
Trigger2
(VN-H57U/H2
57U/H257VP
U/H157WPU
only)
Position
Number
Memo:
If you set the same items for [Trigger1] and [Trigger2], the "Trigger1 and Trigger2 are the same." dialog is
displayed and alarm recording is not started.
Select the 1st trigger to perform an action.
When using VN-H57 series
[Set values： Pin Input1 Make, Pin Input1 Break, Pin Input2 Make,
Pin Input2 Break, Position, Audio Detection1,
Audio Detection2 (VN-H57U/H257U/H257VPU/H157WPU only),
Motion Detection, Tampering Detection, Day/Night, Time]
When using VN-H37 series
[Set values： Position, Motion Detection, Tampering Detection, Time]
Memo:
The trigger for [Trigger1] must first be set to "ON" in the respective [Advanced
Settings] configuration page.
If you set the [Trigger2] to "Disable", an action will be performed when only
[Trigger1] is triggered. (VN-H57U/H257U/H257VPU/H157WPU only)
When "Audio Detection1",
"Position" "Tampering Detection", "Day/Night", or "Time" is selected for the
[Trigger1] trigger, [Interval] and [Trigger2] cannot be selected. (VN-H57U/
H257U/H257VPU/H157WPU only)
This is available when both [Trigger1] and [Trigger2] are set.
Specify the maximum interval between each trigger for [Trigger1] and [Trigger2].
An action will be performed if [Trigger2] occurs within the maximum time interval
after [Trigger1] occurs.
[Set values：1 – 3600 ] sec
Memo:
If you set an invalid value, the "Invalid value" dialog is displayed.
If you leave a value blank, the "Blank value" dialog is displayed.
Select the 2nd trigger to perform an action.
[Set values：Disable, Pin Input1 Make, Pin Input1 Break, Pin Input2 Make,
Pin Input2 Break]
Enabled when "Position" is set for the trigger for [Trigger1].
Perform registration of position numbers via the Built-in Viewer's "PTZ setting".
( "Instructions(Setting)" ─ "Operations" ─ "Built-in Viewer Operations" ─ "PTZ
Settings")
This position condition will also work if you manually move the PTZ, or if the PTZ
is automatically moved via auto patrolling.
[Set values: 0 – 19]
Description
"Audio Detection2",
* The [Set values] in bold letters are factory defaults
16
"Motion Detection",