Mitsubishi Electric DPSClick User Manual page 64

DPSClick User Manual
4.9.3 – Copy to copy
On this screen you will select the scanner type for each mode, be it flatbed scanner or
35mm/slides. It also lists all the scanners installed on the system.
To the right of the box of the flatbed scanner and the film scanner selected you can also
check whether you wish to work with it in Advanced Mode (see section 4.7.1.2). It's also
possible to set the path where the .exe file of the scanner is. For some scanners it's better
to work directly with its own .exe file, instead of work through TWAIN protocol. Remember
also that when the images are scanned they must be saved into work directory (or new
directory inside work directory) to be retrieved from DPSClick.
Flatbed scanner
Advanced Mode
Scanner 35mm/Slides
TWAIN drivers
IMPORTANT: this list will be automatically updated depending on the drivers (TWAIN)
installed on the system.
To add a new Scanner simply install its drivers (have them installed by duly authorised
personnel) and the DPSClick system will detect it automatically and display it in the list.
Calibration
Scratch Clean
NOTE: Only TWAIN type Scanners may be used. Please, contact your dealer for more
information.
64
Type of Scanner selected for flatbed scanner.
DPSClick works with the device manufacturer's own
TWAIN interface and .exe file, also.
Type of Scanner selected for slides or films.
List of scanners installed on the system.
When working with Prime Film 1800 LAB film scanner,
calibration of film position at the beginning of the strip
can be selected.
It activates software dust cleaning procedure for the
Prime Film 1800 LAB film scanner, in two modes: hard
and soft.
v. 4.0