System Hookup; Configuring Your Yamaha Mixing Console; Caution When Using A Usb Connection; Windows Installation - Yamaha Studio Manager V2 Installation Manual

System Hookup

The following illustration shows the available hookup methods
you can use to connect your Yamaha mixing console to your
computer: serial, USB, MIDI.
Yamaha mixing console rear panel
1. Serial
(DM2000/02R96 only)
(Yamaha CCJ-Mac
or equivalent)
Serial cable
(Yamaha CCJ-PC2
or equivalent)
TO HOST
USB
2. USB
USB cable
3. MIDI
OUT IN
MIDI cables
NOTE: Before you connect to serial or MIDI ports, turn off your
Yamaha mixing console and computer.
Configuring Your Yamaha Mixing
Console
Press the DISPLAY ACCESS [SETUP] button to open the MIDI/
TO HOST Setup page. Under "Studio Manager," select a port
and assign an ID to your Yamaha mixing console. If you've
connected the DM2000/02R96 to the serial port, set the TO
HOST SERIAL options as appropriate (i.e., "PC-2" for a
Windows PC, or "Mac" for a Macintosh computer).
Warning: Do not set the TO HOST SERIAL option to "Mac" while
your Yamaha mixing console is connected to your computer's serial
port. Doing so may damage your computer.

Caution when using a USB connection

If you've used the USB TO HOST connector to connect to your
computer, you must perform the following actions. If you fail to
do so, your computer or the connected mixing console may
hang up, causing data damage or loss. If your computer or
mixing console hangs up, turn off the power, and restart your
computer.
• Disable the energy conservation mode (suspend/sleep/
standby/hibernate) on your computer before connecting your
computer via the USB TO HOST connector.
• Connect the USB TO HOST connector to your computer
before powering-on the mixing console.
• Close all application programs (such as StudioManager)
before powering the mixing console on/off or connecting/
disconnecting the USB cable.
• Wait at least three seconds between turning the mixing
console on or off, and between connecting and disconnecting
the USB cable.
Mac or PC
Mac serial port
PC serial port
USB port
MIDI interface
Studio Manager V2 Installation Guide (for DM2000/02R96/DM1000/01V96)

Windows Installation

Adobe Reader

Adobe Reader (available free of charge) must be installed on
your computer in order for you to view the PDF format manuals
for Studio Manager and the various editors. If you don't have
Adobe Reader, access the Adobe Corporation website at the URL
shown below, and download Adobe Reader.
http://www.adobe.com

USB MIDI Driver

If you are connecting your Yamaha mixing console to a USB
port on your computer, you'll need to install the Yamaha USB
driver. If you already have this driver installed, skip this section.
Computer
Studio
Manager
USB cable
Driver
The procedure you use for installing the Yamaha USB driver
depends on which version of Windows you're using:
• Windows 98 & 98SE: See page 6
• Windows Me: See page 7
• Windows 2000: See page 7
• Windows XP: See page 8
NOTE: Studio Manager is supported by only Windows 2000/XP.
The driver for Windows 98/98SE/Me is necessary if you use other
MIDI applications on Windows 98/98SE/Me.
Yamaha
mixing console
5