Advertisement
^ Clean the filters with a soft nylon
brush in a mild solution of hot water
and a little washing-up liquid.
Do not use "neat" washing up liquid.
Do not use:
– cleaning agents containing
descaling agents,
– alkaline cleaning agents (with a pH
value higher than 7), such as powder
cleaners, cream cleaners or abrasive
all-purpose cleaning agents,
– oven sprays.
^ Place the filters with the short side
upright in the lower basket, and wash
on a 65° programme using a mild
dishwasher detergent, ensuring the
spray arm is not obstructed.
Avoid alkaline dishwasher detergents
(with a pH value higher than 7).
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^ After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
When removing the filters for cleaning,
also clean off any residues of oil or fat
from the now accessible housing to
prevent the risk of these catching fire.
When putting the grease filters back in
position, ensure that the locking clips
are facing down towards the hob.
If the grease filters are inadvertently
replaced upside down, insert a small
screwdriver blade into the slits to
disengage the clip.
^ After replacing the grease filters,
press the grease filter control for
approx. 3 seconds to reset the
operating hours counter.
The indicator lamp will go out.
If the grease filters are cleaned
the operating hours counter has
reached its maximum, the grease filter
control should be pressed for approx.
6 seconds to reset the counter to zero.
19
Advertisement
