Checking The Programmed Water Hardness Level - Miele G 611 Plus Operating Instructions Manual

^ Press the "Top Solo" button.
The "Top Solo" indicator light will come
on.
^ Turn the programme selector to the
"Stop" position.
^ Switch the dishwasher off.
The programmed water hardness level
is now stored in memory.
^ Switch the dishwasher off.
^ Turn the programme selector to the
"Stop" position.
^ Press the "Top Solo" button in and
whilst holding it in switch the dish-
washer on using the "On/Off" button.
Release the "Top Solo" button within
two seconds.
The "Salt" indicator light will flash.
If a different indicator light comes on or
flashes, the process must be repeated.
The "Rinse aid" indicator light will come
on if you have not yet added rinse aid
or if rinse aid needs replenishing.
^ Turn the progamme selector from the
"1 o'clock" position as far as the "8
o'clock" position until the "Top Solo"
indicator light comes on.
When the programme selector is at the
position which corresponds to the water
hardness setting already programmed,
the "Start" indicator light will come on
(see chart "Programming and setting
the water hardness level").
^ Turn the programme selector to the
"Stop" position.
^ Switch the dishwasher off.
15