HP 202A Operating And Service Manual page 5

SPECIFICATIONS
r
FREQUENCY RANGE:
0.008 to 1200 cps in five decade ranges with wide overlap a t each
dial extreme.
DIAL ACCURACY:
Within *2% f r o m "1. 2" to "121q on dial; *3% f r o m
".
8" to "1.2".
FREQUENCY STABILITY:
Within
4%
including warm-up drift and line voltage variations of
*lo%.
OUTPUT WAVEFORMS: Sinusoidal, square, and triangular. Selected by panel switch.
MAXIMUM OUTPUT VOLTAGE:
At least 30 volts peak-to-peak across rated load (4000 ohms) for all
three waveforms. (10.6 volts RMS for sinewave. )
FREQUENCY RESPONSE:
Constant within *0.2 db over entire frequency range a t rated output
and load.
lNTE RNAL IMPEDANCE :
Approximately 40 ohms over the entire range.
DISTORTION:
Less than 1% on all ranges except X100. Less than 2% r m s on X100.
OUTPUT SYSTEM:
Can be operated either balanced o r single-ended. Output system
is direct-coupled; dc level of output voltage remains stable over
long periods of time. DC adjustment available on front panel.
HUM LEVEL:
L e s s than 0.05% at rated output.
SYNC PULSE :
10 volts peak negative, l e s s than 5 microseconds duration. Sync
pulse occurs a t c r e s t of sinewave and with corresponding positions
on other waveforms.
POWER: Operates from ll51230V
-+lo%,
5011000 cycles source. Requires
17 5 watts.
DINENSIONS: Cabinet Mount: 20-314" wide, 12-112" high, 14-112" deep.
Rack Mount: 19" wide, 10-l/21qhigh, 14-11 4" deep.
WEIGHT: Cabinet Mount: 48 lbs; shipping weight, approximately 84 lbs.
Rack Mount:
36 lbs; shipping weight, approximately 74 lbs.
ACCESSORIES AVAILABLE:
F o r rack mount style: End F r a m e s with handles f o r bench use.
Specify @No. 17 End Frames.