Table of Contents
Advertisement
Pin
1
2 & 3
4
7. Device configuration jumper
These pins allow you to select either Master, Slave, or Cable Select
mode for the DVD-ROM device. ( Refer to page 18 for jumper settings. )
Pin
1
2
3
8. Host IDE in
terface
This connector is for a 40-pin IDE cable to connect the drive to the IDE
interface on the motherboard.
9. DC input
This DC connector is for a 4-pin power cable from the system power supply.
Name
L
Left channel audio output
G
Ground
R
Right channel audio output
Name
Switch Status
MA
ON
SL
ON
CS
ON
ASUS DVD-E616P2
Description
Description
Master mode
Slave mode
Cable select mode
17
Advertisement
Table of Contents
