Deleting Photo Data - Toshiba gigabeat T Series User Manual

NOTE

Deleting photo data

You can delete photo data retrieved directly from the digital camera,
without connecting the gigabeat
1 Select my pictures on the start screen, and press the OK
button.
2 Press the Left or Right button on the PlusPad™ to select view
by folder.
Retrieving photo data from a digital camera
Charge the gigabeat
digital camera. If data is transferred from the digital camera
while the gigabeat
®
gigabeat may be damaged when the battery runs out in the
middle of transfer operation.
Do not unplug or plug the USB cable while the gigabeat
processing.
Depending on the type of the digital camera, you may need to
switch the camera to an appropriate mode beforehand so that it
can connect to a computer, etc.
®
If the gigabeat
amount of photo data that can be stored in the available space
will be transferred.
Do not use a USB hub to connect the digital camera and
®
gigabeat .
Due to the limitation imposed by the gigabeat
power-supply function, some digital camera models may not
be connected to the gigabeat
®
of the gigabeat
remove the digital camera, turn OFF the gigabeat
then turn on the power again.
®
The gigabeat can only recognize one folder in the connected
digital camera. If the digital camera has two or more storage
folders, only one will be recognized.
Photos and your gigabeat®
®
sufficiently before connecting it to the
®
battery power is low, data recorded in the
has not enough available space, only the
®
or may cause the USB function
to be disabled temporarily. In this case,
®
to your computer.
59
®
is
®
USB bus
®
power, and