Easy Calibration - Sharp AR-C260P Key Operator's Manual

DESCRIPTION OF PROGRAMS

Easy calibration

Use Easy Calibration when there is only a small
difference between the colours in the colour chart
and the test page that was printed as explained on
page 14.
Follow the steps below to set the colour
balance.
Display "EASY CALIBRATION" as indicated in
1
the chart on page 29.
EASY CALIBRATION
Press the [OK] key.
2
TEST PAGE PRINT
-OK?
Load A4 or letter-size paper in the tray and press
3
the [OK] key.
When the [OK] key is pressed, "PRINTING." appears
in the display.
After a brief interval, a test page for easy calibration
will be printed (see the following page).
Select the colour of grey that you prefer in the
4
test patterns (Test pattern 2 and Test pattern 3 on
the following page).
For a detailed explanation of this procedure, see
"Easy Calibration" on the following page.
Press the [ ] or [
5
(-3 to 3) of the preferred grey colour (this is the
magenta component of the colour).
SELECTION X POSITION
Press the [OK] key.
6
Press the [ ] or [
7
(-3 to 3) of the preferred grey colour (this is the
yellow component of the colour).
SELECTION Y POSITION
Press the [OK] key.
8
Your settings will be saved and you will return to the
display of step 1. Print a test page as explained on
page 14 and verify that the colours match the colours
in the standard colour chart.
NOTE
If you cannot find an acceptable colour of grey
in the test patterns, adjust the colour balance
using the Colour Balance settings as explained
on page 16.
18
This message will
appear.
] key to enter the X-axis value
0
] key to enter the Y-axis value
0