Assembly - Bosch GTA3800 Operating/Safety Instructions Manual

BM 2610013406 06-10:BM 2610013406 06-10 6/14/10 9:52 AM Page 6
TooLS NEEDED FoR ASSEMBLY
• Included Multi-purpose Wrench
pREpARING THE STAND
1. Lay the stand's top surface down on the
floor with the folded legs on top.
2. Push in a leg locking pin and rotate that leg
up until the locking pin clicks into place. See
Fiqure A.
3. Repeat with the remaining three legs.
4. Lift the stand by the carrying handle and
place it in an upright position.

Assembly

5. Check to ensure the stand is stable and all
the legs have the locking pins engaged.
To LEvEL STAND
The stand is equipped with an adjustable foot
for leveling the stand.
To adjust, turn the foot clockwise to raise leg or
counter-clockwise to lower the leg See. Figure B.
and level before operating the saw. Choose
a level area to set-up the stand and adjust the
adjustable foot so that all four legs are
touching the ground.
To reduce the risk of injury,
insure the stand is stable