Page 1
Check your storm windows= if you storm window frame does not allow the clearance required, correct by adding a piece of wood as shown in FIG.2, or by removing storm window while room air conditioner is being installed. unit. (continued) 19"...
Page 2
Power supply core NIth 3-prong groundi plug and current detection device 6. Carefully unpack air conditioner material. Protect floor or carpet from damage. Two people should be used to move and install unit. for things Inside, be sure cord...
9. Your unit may come with internal packaging.THIS PACKAGING MUST BE REMOVED PRIOR TO INSTALLING THE AIR CONDITIONER INTO THE CABINET. (See FIG. 5). Install and Side Bracket Attach foam gasket to top angle above holes as shown in FIG.
Page 4
3. Insert top and bottom legs of window filler panel frame into channel in the to angle and bottom rail. Do both sides. Insert washer head locking screws (2) into holes in top leg d filler panel frame (see Step 6). Do not totally tighten.
Page 5
LOCK 3/4" }orlg hex- install Filler Cabinet Front to Unit 1, Lift air conditioner leaving 6" protruding, 2. _DO 3, Be sure chassis is firmly seated towards rear of cabinet. 4. Installation of front is the reverse of removal outlined in Section 1.
NOTE: Consult local building codes prior to installation, or a qualified carpenter. Select Wall Location This air conditioner has a slide-out chassis, so that it can be installed through an outside wall as specified below: Heavy Duty(FAS) Max wall thickness 10"...
Page 7
NOTE: If wall thickness is 8-1/2" or more, add aluminum flashing over bottom of frame opening to assure no water can enter area between inner and outer wall. ALUMINUM FLASHING OVER BOTTOM OF FRAME Prepare and Install Cabinet 1. Slide chassis from cabinet. Refer back to Step 1 of Window Mounting.
OPTIONAL: Caulking and installation wall may be done. You can buy wood from your local lumber or hardware supply. On the outside, caulk openings and sides of cabinet, and all sides of wood sleeve to the opening. NOTE: See Step 7, Item 3 of Window Mounting for bottom rail seal location.