Frigidaire MWTK(P)27K Installation Instructions Manual

Built-in trim kit for microwaves
Hide thumbs Also See for MWTK(P)27K:
Table of Contents

Advertisement

Available languages

Available languages

Installation
Instructions

BEFORE YOU BEGIN

IMPORTANT
for local inspector's use.
IMPORTANT
codes and coordinates.
Note to Installer
these instructions with the Consumer.
Note to Consumer
instructions for future reference.
Skill level - Installation of this appliance
requires basic mechanical and electrical
skills
FOR YOUR SAFETY:
WARNING
– Before beginning the installation,
switch power off at service panel and lock the
service disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to
the service panel.
Installation Instructions
– Save these instructions
– Observe all governing
– Be sure to leave
– Keep these
Built-in Trim Kit
MWTK(P)27K and MWTK(P)30K
Read these instructions completely and carefully.
Proper installation is the responsibility of the
installer.
Product failure due to improper installation is
not covered under the Warranty.
Unplug the microwave oven before
attempting installation of this kit.
Because the kit includes metal parts, caution
should be used in handling and installation to
avoid the possibility of injury.
Do not remove permanently affixed labels,
warnings, or plates from the product. This
may void the warranty.
IMPORTANT - PLEASE READ
AND FOLLOW
THIS BUILT-IN KIT IS DESIGNED FOR USE
ONLY WITH ELECTROLUX MICROWAVE
OVENS SPECIFYING BUILT-IN KIT
MWTK(P)27K OR MWTK(P)30K ON THE RATING
LABEL ON THE LEFT SIDE WALL OF THE
MICROWAVE OVEN CAVITY.
QUESTIONS?
For customers in the United States call: 1-800-944-9044
For customers in Canada call: 1-800-265-8352 (English)
1-800-668-4606 ext.8199 (French)
Visit our Website at: www.frigidaire.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
1
PN316495084
SEPT 2009

Advertisement

Table of Contents
loading

Summary of Contents for Frigidaire MWTK(P)27K

  • Page 1: Before You Begin

    AND FOLLOW THIS BUILT-IN KIT IS DESIGNED FOR USE ONLY WITH ELECTROLUX MICROWAVE OVENS SPECIFYING BUILT-IN KIT MWTK(P)27K OR MWTK(P)30K ON THE RATING LABEL ON THE LEFT SIDE WALL OF THE MICROWAVE OVEN CAVITY. QUESTIONS? For customers in the United States call: 1-800-944-9044 For customers in Canada call: 1-800-265-8352 (English) 1-800-668-4606 ext.8199 (French)
  • Page 2: Installation Instructions

    PARTS INCLUDED IN THE KIT 1. Front Frame Assembly - QTY 1 2. Exhaust Duct Assembly - QTY 1 3. Screw A - QTY 2 4. Screw B - QTY 4 CHOOSING A LOCATION FOR YOUR MICROWAVE OVEN IF BUILT-IN Built-In Trim Kit allows for the installation of microwaves listed below to be built into a cabinet or wall by itself or over an electric wall oven*.
  • Page 3: Electrical Outlet Location

    Illustration 2 ELECTRICAL OUTLET LOCATION Outlet should NOT be in the shaded area as indicated on Illustration 2 NOTE 1: If the Depth (C) dimension is greater than 21” (53.3 cm), the outlet location may be in any area on the rear wall. NOTE 2: The floor of the opening should be constructed of plywood strong enough to support the weight of the...
  • Page 4: Frame Installation

    FRAME INSTALLATION Place the oven adjacent to the wall or cabinet opening. Plug the power cord into the electrical outlet. Carefully guide the assembled oven into the prepared opening. Slide the oven on the Exhaust Duct Assembly. See Illustration 4. Avoid pinching the cord between the oven and the wall.
  • Page 5: Pour Votre Sécurité

    CET ENSEMBLE DE GARNITURE À ENCASTREMENT EST DESTINÉ UNIQUEMENT AUX FOURS À MICRO-ONDES ELECTROLUX EXIGEANT UNE TELLE GARNITURE. LA MENTION MWTK(P)27K OU MWTK(P)30K FIGURE SUR L’ÉTIQUETTE DE TENSION DE SERVICE, SUR LA PAROI LATÉRALE GAUCHE DE LA CAVITÉ DU FOUR À MICRO-ONDES.
  • Page 6: Instructions D'installation

    Instructions d'installation PIÈCES INCLUSES 1. Cadre avant – QTÉ 1 2. Conduit d’évacuation – QTÉ 1 3. Vis A – QTÉ 2 4. Vis B – QTÉ 4 CHOIX DE L'EMPLACEMENT DE VOTRE FOUR À MICRO-ONDES ENCASTRÉ L’ensemble de garniture d’encastrement est compatible avec les fours à...
  • Page 7 Instructions d'installation Illustration 2 EMPLACEMENT DE LA PRISE DE COURANT La prise de courant ne doit PAS être placée dans la zone ombrée, comme le montre l’illustration 2. REMARQUE 1 : Si la profondeur (C) de l’ouverture dépasse 53,3 cm (21 po), la prise de courant peut être placée à...
  • Page 8: Installation Du Cadre

    Instructions d'installation INSTALLATION DU CADRE Placer le four à côté de l’ouverture pratiquée dans l’armoire ou le mur. Brancher le cordon d’alimentation dans la prise de courant. Guider avec soin le four assemblé dans l’ouverture pratiquée à cet effet. Glisser le four sur le conduit d’évacuation.
  • Page 9: Para Su Seguridad

    ESTÁ DISEÑADO PARA SU USO SOLAMENTE CON HORNOS DE MICROONDAS DE MARCA ELECTROLUX QUE ESPECIFIQUEN EL USO DE UN KIT PARA INSTALACIÓN EMPOTRADA. MWTK(P)27K o MWTK(P)30K EN LA ETIQUETA DE VALORES NOMINALES UBICADA EN LA PARED IZQUIERDA DE LA CAVIDAD DEL HORNO DE MICROONDAS.
  • Page 10: Instrucciones Para La Instalación

    Instrucciones para la instalación PARTES QUE SE INCLUYEN EN EL KIT 1. Conjunto de marco frontal – CANT. 1 2. Conjunto de conducto extractor – CANT. 1 3. Tornillo A – CANT. 2 4. Tornillo B – CANT. 4 SELECCIÓN DE LA UBICACIÓN DE SU HORNO DE MICROONDAS PARA EMPOTRAR El kit para instalación empotrada permite instalar los hornos de...
  • Page 11 Instrucciones para la instalación Ilustración 2 UBICACIÓN DEL TOMACORRIENTE El tomacorriente NO debe encontrarse en el área sombreada que se indica en la Ilustración 2. NOTA 1: Si la dimensión de la profundidad (C) es de más de 21 pulg. (53.3 cm), la ubicación del tomacorriente puede estar en cualquier área de la pared posterior.
  • Page 12: Instalación Del Marco

    Instrucciones para la instalación INSTALACIÓN DEL MARCO Coloque el horno en posición adyacente a la abertura de la pared o del gabinete. Enchufe el cordón eléctrico en el tomacorriente. Guíe cuidadosamente el horno ensamblado hacia el interior de la abertura preparada. Deslice el horno sobre el conjunto de conducto extractor.

Table of Contents