Philips CED1700 User Manual page 11

Connector/Obeject
1 Pink wire
2 2.5m extension wire
(Not included)
3 Brake switch
4 Ground
5 ISO wires
6 Grey wire
7 Black wire
8 Blue cable
9 Red cable
10 White cable
11 Yellow cable
12 Yellow cable
13 Yellow cable
14 Yellow cable
15 Purple wire
16 Gearbox switch
17 Reverse gear signal
Connect radio antenna
Connect the radio antenna to the radio antenna of the system for
better radio signal.
1
Connect the radio antenna to the car antenna.
Connect external navigation box
This unit supports GPS navigation by connecting Philips CEA100
external GPS navigation box.
Connect to/with
Extension wire
Parking brake (-)
Connected in step 1 above.
Rear line out Left/Right
Front line out Left/Right
Subwoofer
Aux Right
Aux Left
Video in
Camera in
Video out 1
Video out 2
Reverse camera (B+)
Back lamp lead +
Note
‡
Please consult your Phillips dealer or distributer to purchase the CEA100 external
navigation box.
Mount in the dashboard
Note
‡
Check wire connection before you mount the unit into a car.
‡
If preset radio stations are lost when the ignition key is turned OFF and then back
ON, reconnect the red leads crosswise to the yellow ones.
1
If the car does not have an on-board drive or navigation
computer, disconnect the negative terminal of the car battery.
‡ If you disconnect the car battery in a car that has an on-
board drive or navigation computer, the computer may lost
its memory.
‡ If the car battery is not disconnected, to avoid short-circuit,
ensure that bare wires do not touch each other.
2
Ensure that car dashboard opening is within these
measurements:
EN 11