Advertisement
INSTALLATION
INSTRUCTIONS
DOOR LOCK/SWITCH
KIT - P/N 131888900
This kit replaces
the Bitron door lock/switch with a US Controls door lock/switch.
This kit contains the following parts:
(1) Door Lock/Switch
(1) Door Strike
(1) Adapter Harness
(1) Tube Adhesive
(6) Plastic Harness Ties
(1) Installation
Instruction
1.
Disconnect
the washer
from
the electrical
power
source.
2.
Remove the front service panel.
3.
Open the door, remove the two screws securing
the
door strike to the door and remove the strike.
4.
Install the new door strike using the screws removed
in step 3.
5.
Using a razor blade or a sharp putty knife, separate
the bellows
from the front panel
at the 2, 3, & 4
o'clock positions.
6.
Remove
the
screws
securing
the
old
door
lock/switch
to the front panel.
7.
Remove the wires from the old door lock/switch
and
remove the switch.
8.
Remove the nine pin plug
from the speed control
unit (SCU).
9.
NOTE: Iftlae washer serial number prefix is XC703
and above, go to step 13. If the washer serial number
is below
XC703,
proceed
with
instructions
10
through 12.
10. In slot number
2, insert a small
wire (paper
clip)
between the locking tab of the red wire terminal and
the housing.
Note: The locking tab is located in the
small rectangular
slot below the terminal. DO NOT
push
down
on the contact
prongs
on the wire
terminal.
11. Pull the red wire out of the slot.
12. Insert
the red wire into
slot number
4 until the
terminal
clicks into the housing.
Gently pull on the
wire to ensure it is fully seated in the housing.
13. Remove the connector
plug from the pump. NOTE:
Removing
the
pump
cover
on pumps
with
an
external cooling fan will make it easier to access the
connector
plug.
14. Connect the nine pin plug from the adapter
harness
to the to the SCU.
P/N 131888800
8/99
Advertisement
