Controller; Z-Series, S4810; Debug Openflow Packets - Dell Force10 Software Defined Networking Deployment Manual

controller

Specify the OpenFlow controller configuration that the OpenFlow instance uses to establish a connection.

Z-Series, S4810

Syntax controller {controller-id}{ip-address}[port port-number]tcp
Parameter
controller-id
ip-address
port-number
port
Defaults Default port number for the TCP connection is 6633.
Command Modes OPENFLOW INSTANCE
Command History
Version 9.1(0.0)
Usage The controller number must be entered as 1 to enable OpenFlow. Currently, only TCP
Information connection is supported.
Related openflow of-instance
Commands

debug openflow packets

Enable debugging for OpenFlow packets.
Z-Series, S4810
Syntax debug openflow packets {packet-type packet-type} of-instance
{of-id}
Parameter
{packet-type
packet-type }
28
Enter the controller number (must be 1).
Enter the IP address of the controller.
Enter the keyword port followed by the port number to use for the
connection. Range is 1 to 65535.
Introduced on Z9000 and S4810.
Create or modify an OpenFlow instance.
Enter the keyword packet-type followed by one of the following
packet types:
all Enable debugging for all packets.
barrier-reply Enable debugging for barrier-reply packets.
barrier-request Enable debugging for barrier-request
packets.
echo-reply Enable debugging for echo-reply packets.
echo-request Enable debugging for echo-request packets.
error Enable debugging for error packets.