Setting The Scsi Id - Dell PowerVault 110T DLT1 Drive User Manual

Getting Started and Setup: Dell PowerVault 110T DLT VS160 Tape Drive User's Guide
NOTE: Save the packing materials in case you need to move or ship your drive in the future. You must ship the
PowerVault 110T DLT VS160 Tape Internal drive in the original or equivalent packing materials or your warranty may be
invalidated.

Setting the SCSI ID

Regardless of the number of SCSI devices attached to the server that is to be the host for the PowerVault 110T DLT VS160 Tape
Internal drive, each must have a unique SCSI ID. Check the SCSI IDs on all other SCSI devices on the selected server, including
the SCSI host adapter, and select an unused SCSI ID for the PowerVault 110T DLT VS160 Tape Internal drive. The factory default
SCSI ID is 6. If another device is not already using the factory default SCSI ID, you do not need to change the drive's SCSI ID.
NOTE: If you attach the drive to a narrow (50-pin) bus, you can only use SCSI IDs 0 through 7.
Locate the SCSI ID jumpers on the rear panel of the drive as shown in Figure 1.
Figure 1. SCSI ID jumpers on rear panel of drive
To set the SCSI ID on the PowerVault 110T DLT VS160 Tape Internal drive, use the supplied jumpers to select the desired SCSI
ID as shown in Table 1. After you change the SCSI ID, restart the host server to activate the new SCSI ID and to allow the server
to recognize the drive at the new ID.
Table 1. SCSI ID jumper settings
file:///C|/Users/rishi_sood/Desktop/Temp/MissingDocsPosted/110t_dlt/UG/setup.htm[3/8/2013 11:46:12 AM]