Serial Communications Screen; System Profile Settings Screen - Dell External M620 t Owner's Manual

Menu Item Description
SR-IOV Global Enable Allows you to enable or disable the BIOS configuration of Single Root I/O Virtualization (SR-
IOV) devices. By default, the SR-IOV Global Enable option is set to Disabled.
Slot Disablement The Slot Disablement feature controls the configuration of mezzanine cards installed in the
specified slots. Only mezzanine card slots that are present on your system are available for
control.

Serial Communications Screen

Menu Item Description
Serial Communication Allows you to enable the COM port or Console Redirection options.
Serial Port Address Allows you to set the port address for serial devices. By default, the Serial Port Address option
is set to COM1.
Failsafe Baud Rate Displays the failsafe baud rate for console redirection. The BIOS attempts to determine the
baud rate automatically. This failsafe baud rate is used only if the attempt fails and the value
must not be changed. By default, the Failsafe Baud Rate option is set to 11520.
Remote Terminal Allows you to set the remote console terminal type. By default, the Remote Terminal Type
Type option is set to VT 100/VT220.
Redirection After Allows you to enable or disable to the BIOS console redirection when the operating system is
Boot loaded. By default, the Redirection After Boot option is set to Enabled.

System Profile Settings Screen

Menu Item Description
System Profile Allows you to set the system profile. If you set the System Profile option to a mode other than
Custom, the BIOS automatically sets the rest of the options. You can only change the rest of the
options if the mode is set to Custom. By default, the System Profile option is set to Performance
Per Watt Optimized (DAPC). DAPC is Dell Active Power Controller.
CPU Power Allows you to set the CPU power management. By default, the CPU Power Management option
Management is set to System DBPM (DAPC). DBPM is Demand-Based Power Management.
Memory Frequency Allows you to set the memory frequency. By default, the Memory Frequency option is set to
Maximum Performance.
Turbo Boost Allows you to enable or disable the processor to operate in turbo boost mode. By default, the
Turbo Boost option is set to Enabled.
NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To use console
redirection by SOL, configure the same port address for console redirection and the serial
device.
NOTE: The following parameters are available only when the System Profile is set to
Custom.
17