Channel Menu
Select Antenna / Cable
Select Antenna or Cable for the service connected to your TV.
1
Press MENU.
2
to select "Channel", then press or OK.
Press
or
3
to select "TV Mode", then press or OK.
Press
or
4
to select "Antenna" or "Cable", then press OK.
Press
or
Scan Channels
Auto Scan Channels
When you run auto scan, the TV scans for all available channels. Make sure the antenna/cable is
connected properly. See page 14.
1
Press MENU.
2
to select "Auto Channel Scan", then press or OK.
Press
or
3
to select "Start Scan", then press OK.
Press
or
Scanning progress is displayed on the menu screen. To stop scanning, select "Stop Scan" and press
OK.
Note: Auto scan may take 15 to 30 minutes to find available channels.
Partial Scan Channels
You can partially scan for network signal within a specified range of channels.
1
Press MENU.
2
to select "Partial Channel Scan", then press or OK.
Press
or
3
to select "Scan Mode", then press or OK.
Press
or
4
to select an option, then press OK.
Press
or
• "Analog/Digital": scan for both analog and digital channels
• "Analog": scan for analog channels
• "Digital": scan for digital channels
5
Press
or
to select "From Channel", then enter a starting channel range.
6
Press
or
to select "To Channel", then enter an ending channel range.
7
to select "Start Scan", then press OK.
Press
or
Scanning progress is displayed on the menu screen. To stop scan, select "Stop Scan" and press OK.
30
Audio
Adjusting the Menu Settings
Setup
PIP
TV Mode
Closed Caption
Auto Channel Scan
Partial Channel Scan
Wide
Find Channel
Channel Management
Channel
Digital MTS
Cable
English