D-Link DCS-60 User Manual page 2

Ⅲ. Fitting instructions for camera
Fig.3
1. Unscrew the 3 captive Retaining Screws (C) and remove the Housing Cover (A) from the Housing
Base (B).
2. Release the 4 Keyhole Screws (F) and then slide and withdraw the Camera Platform (G) from the
Housing Base (B).
3. Mount the Camera (H) onto Platform (G) using the 1/4" UNC Screw ( I ) supplied, ensuring that
the Insulation Pad (J) is mounted between the Platform and the Camera. Always check that the
Camera is firmly attached to the Platform.
4. Connect the Camera / Heater power cable to the rear Terminal Block (E) through the first Cable
Conduit (D) referring to the circuit diagram shown in section IV. for the terminal designations.
5. Connect the video cable to the Camera through the second Cable Conduit(D).
IMPORTANT NOTE:
ALWAYS UNPLUG THE TOP SECTION OF THE EARTH WIRE FROM THE BASE WIRE WHEN
DISASSEMBLING THE HOUSING. REMEMBER TO PLUG THE TOP AND BOTTOM TOGETHER
AGAIN WHEN REASSEMBLING THE HOUSING.
Ⅳ. Wiring diagram
Fig.4 shows the internal wiring diagram of
DCS-60 for the window demister.
When necessary, a spare 6 way terminal
block is provided at the rear of the enclosure
for the camera and lens connections.
Circuit identified as follows:
TB.1 6 way terminal block
TB.2 3 way terminal block
FTB.1 Fused terminal block
FS.1 3 Amp. Fuse
STAT.1 28℃ Thermostat
STAT.2 35℃ Thermostat
H.1 Heater
B.2 Blower
P.C.B.1 Thermal control circuit board
(H)
(G)
(F)
(J)
(G)
(I)
Fig.4 Wiring diagram of DCS-60
2
1 Heater
2 Heat shield
3 Thermal control board
4 Camera mounting platform
5 Terminal block assembly
6 Cable conduits PGB11 x 2
7 Captive retainning Screws x 4
8 Heater & blower wires, Ground wire
9 Ground wire
10
Blower
TURN OFF AT 28℃ RISING TEMPERATURE
TURN ON AT 18℃ DECREASING TEMPERATURE