Notes - Fujitsu Solaris PCI GigabitEthernet 3.0 User Manual

Appendix C Using GigabitEthernet in a Cluster Environment
C.3

Notes

● SynfinityCluster 2.0 or later or PRIMECLUSTER 4.1 or later is required when using
the FUJITSU PCI GigabitEthernet interface. If an earlier version of cluster software
is used, GigabitEthernet cannot be used as the private LAN or for IP address fail-over
on a public LAN.
● When using a FUJITSU PCI GigabitEthernet interface as a SynfinityCluster private
LAN or as the PRIMECLUSTER cluster interconnect, execute the following command
before setting up the cluster (example: fjgi0).
# ifconfig fjgi0 plumb
● A FUJITSU PCI GigabitEthernet interface used as a VLAN interface cannot be used for
the private LAN or the cluster interconnect.
72