Panasonic EY3551 - 18V WOOD SAW Specifications page 8

EY3551-X8 / EY3552-X8
Procedure 3A → → → → 3B
Ref. No. 3B
Ref. No. 3C Procedure 3A → → → → 3B → → → → 3C
Assembly of the spindle lock button and gear box.
1. Push and hold the spindle lock button while inserting the gearbox
block.
NOTE:
Confirm the direction of the spindle lock button. Place D-cut on
top.
In case of the spindle lock button hardly insert into the gearbox
block, rotate the shaft of gearbox slowly by hand.
Make sure that the spring is set in the circule properly.
2. Tighten the 4 screws crossing.
NOTE:
Make sure to align the triangle mark of the gearbox with the
housing.
Assembly of the switch.
1. Wiring the thin white lead wire and the black motor lead wire on
the proper positions.
2. Attach the battery terminals.
3. Wiring the white motor lead wire together with the thin white lead
wire.
4. Place the white lead wires (for braking) passes through between
the black and white motor lead wires.
5. Press fit the thin white lead wire (for braking) between screw
bosses firmly.
NOTE:
Be certain the lead wires are mounted in the proper position.
Make sure that they are not set on the screw bosses or over the
housing ribs.
8