Advertisement
58_0497_02.fm Page 3 Tuesday, July 10, 2001 2:18 PM
INSTALLING THE RADIO ANTENNA COVER
To attach the radio antenna cover to the pen tablet PC,
perform the following steps.
1. Position the antenna cover in relation to the back of the
pen tablet PC as shown in Figure 2.
2. If caps are present over the mounting holes, remove
them with a small screwdriver, or similar tool.
3. If the FMW42CR2 antenna cover is being used, slide the
open slot in the cover (as outlined in Figure 2) over the
antenna so that the antenna protrudes from the cover.
4. Insert the antenna cover tabs into the two tab slots on
the pen tablet.
Note: If the screws referenced in the step below are either lost or
missing, they can be purchased at most hardware stores (Cross-recessed
head Machine Screw with spring washer and flat washer. Size: M2.5 x
8 mm long. Finish:Black Zinc)
5. Insert the two black screws through the holes in the
hood and secure them to the pen tablet.
Tab Slots
Antenna Slot
(FMW42RC2
model only)
Figure 2. Installing the Radio Antenna Cover
Mounting
Hole
Tab
PC Card Slot
3
Advertisement
